Benchy Sparkling - Instruction Manual
Page
4
of
16
www.KegLand.com.au
Last Updated 3/06/2022 6:03 PM
Important Warnings
Before Installation:
1.
Let the Benchy Sparkling sit for at least 24 hours after delivery or after sitting on its side
before turning the unit on.
2.
Ensure the under-counter cupboard or bench top can support the weight of the Benchy
Sparkling when full of water.
3.
Ensure there is adequate ventilation (at least 100mm on each side of the Benchy Sparkling)
Do not exceed the pressures which are stated on the data plate.
Do not set the reservoir temperature to below 2°C
Installation Check List
I have checked that the under-counter space or bench top can support the weight of the unit
when full.
I have ensured there is a minimum of 100mm clearance on each side of the unit.
I have stood the unit upright for minimum 24 hours before switching on.
I have ensured the mains water supply and CO2 gas supply remain off during assembly.
I have ensured the mains water is off and the system is completely depressurised prior to
removing any hosing from push in fittings.
I have set the reservoir temperature to 2°C or greater
I have not exceeded the pressures which are stated on the data plate on the unit.
I have read and followed the instruction manual in its entirety and will now conduct a leak test
prior to leaving the unit unattended.
