RAPT Fermentation Chamber Instruction Manual
Page
9
of
13
www.KegLand.com.au
Last Updated 1/03/2022 4:36 PM
SWAPPING THE DOOR OPENING DIRECTION
Included with every RAPT chamber are spare hinges that allow for the orientation of the door to be
changed from right side opening to left side opening.
To change the hinge side of the RAPT fermentation chamber, you will need to remove the right hand
hinges and install the replacement left hand hinges.
The bottom hinges are accessed by removing the dismountable drip tray cover (above).
To access the top hinges, remove the top panel of the RAPT chamber.
Follow the above instructions for installing the inline regulator to remove the two front panels. Then
remove the 6 screws holding the plastic top cover in place. Once the top hinge can be accessed, it is
removed by unscrewing from the RAPT chamber.
To swap the door hinge side, remove the top right hinge. Then carefully lift the door off the bottom
hinge pin and place in a safe place. Unscrew the bottom right hinge.
Perform this in reverse to install the left hinges. Install the left bottom hinge. Carefully align the door
onto the left bottom door hinge pin. Then install the left top hinge and replace the top cover.
It is recommended that this is performed by two people to minimise the risk of damage during the
process.
PROFILES
Profiles are a key component of the RAPT system. Profiles are powerful tools that can be customised
to a great degree, allowing extremely fine control over all aspects of brewing/fermentation.
Profiles can be designed in the RAPT Portal. There are also Global Profiles that can be imported and
customised . Once a profile is created in the RAPT Portal, it can be sent to the corresponding RAPT
device using the Send Profile To Device option in the RAPT Portal. The RAPT ecosystem is intended
to be largely controlled remotely, and thus there are more powerful controls in the RAPT Portal.
To start or amend a profile that has been uploaded to the RAPT device select PROFILES from the
main menu
This will display the currently selected profile. If no profile is running, any profile that has previously
been sent to the RAPT device can be selected and started from this screen.
