T-GPS User Manual Version 1.2 | 30
6.
Installation and Adjustment
6.1
Delivery Inspection
•
Ensure that the contents match the items in the order. Refer to Appendix A.
•
Check that all required components are present.
•
Check the packaging is undamaged and has not been opened. If damaged the packaging
should be photographed and retained.
•
Check for any damage to the product. In case of damage; take photographs, provide a
description of the damage and obtain a signature from the freight agent.
•
Check that the labelling of the T-GPS3000 corresponds with the order.
If there are any of the above issues at the point of delivery ensure Kehui is notified without delay.
6.2
Installation
T-GPS3000 is designed for installation in a standard 19-inch rack. It can be mounted alone or with
other devices as shown here.
The dimensions of the unit are shown below (Figure 6.1):
Figure 6.1 Case dimensions
To mount the unit into a panel there are four screws on the front.
Note
: Leave 5cm above and below the unit to allow for heat dissipation.
Loosen the screws of the cabinet at the point of installation of the T-GPS-3000.
Install the unit from the front of the cabinet, and align the front panel to the holes.
Figure 6.2 T-GPS3000
rack-mounted in a cubicle
