background image

1021 

|

 1022 SMALL AIR COMPRESSOR

10

WARRANTY STATEMENT

REGULATORY AND COMPLIANCE NOTICES

For information about Keiser’s product warranty and thereto related information, refer to keiser.com/support/warranty.

COMPLIANCE

This device complies with Industry Canada Licence-Exempt RSS standard(s). Operation is subject to the following two conditions: 
(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may 

cause undesired operation of the device.
Le present appareil est conforme aux CNR d'industrie Canada applicables aux appareils radio exempts de licence. L’exploitation 

est autorisee aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit 

accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible d’en compromettre le fonctionnement.

REGULATORY NOTICE

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the 
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. 
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will 
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which 
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or 
more of the following measures:

—   Reorient or relocate the receiving antenna.
—   Increase the separation between the equipment and receiver.
—   Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—   Consult the dealer or an experienced radio/TV technician for help.

California Proposition 65 Warning: 

This product contains chemicals known in the State of California to cause cancer, 

birth defects, and/or other reproductive harm.

This equipment contains electrical or electronic components that must be recycled properly to comply with 
Directive 2002/96/EC of the European Union regarding the disposal of waste electrical and electronic equipment 

(WEEE). Contact your local dealer for procedures for recycling this equipment.

Summary of Contents for 1021













Reviews: