M3i INDOOR GROUP CYCLE
11
Prepare for Flywheel Guard Installation.
(a) Install the Clamps to the Flywheel Guard, finger-tight
(Items D, E, and F).
(b) Place the open end of the Flywheel Guard onto the
Mount Stud, then pivot the Flywheel Guard into position.
Prepare for Flywheel installation.
It is recommended to remove x2
Flywheel Guard Mount Screws
and Washers from the Base for
easy installation later in the
assembly procedure (Tool: 5 mm
Hex Key).
Align and secure the Flywheel Guard.
(a) Attach the Clamps to the Base using x2 Mount Screws
and Washers (removed in Step 5), finger-tight. Align the
Flywheel Guard to the Flywheel.
(b) Once the Flywheel Guard is aligned, tighten x2 Mount
Screws using a 5 mm Hex Key. Complete installation by
tightening the Bolt and Nut (Items D and E) using two
10 mm Wrenches.
5
7
(a) Pivot the Flywheel
into the folded paper
and onto the Hub. Push
the Flywheel against
the Hub until it is fully
seated. Align the screw
holes, and discard the
folded paper.
(b) Place the Hub Cap
onto the Hub. Align the
screw holes. Start five
SHC Screws (Item C).
(c) Tighten the screws
in a star pattern until
snug using a 5 mm Hex
Key.
DO NOT OVERTIGHTEN
MAY DAMAGE THREADS.
6
8
IMPORTANT: Failure to follow these instructions can
lead to cosmetic damage to the Flywheel.
Move Shifter to the down position. Wedge a
piece of paper between the Magnets.
Hub Cap
C
(align screw holes)
Magnets
Paper
Shifter
D
E
D
E
F
HOW TO ASSEMBLE THE M3i BIKE
Bikes sold in the European Union: Apply Hub Cover Decals over each
of the screw holes (Item L, not shown).
Hub
Flywheel
Paper
Flywheel Guard
Mount Stud
