555518_A
p3.
M3i INDOOR GROUP CYCLE
OPERATION
1.
Read these instructions.
2.
Keep these instructions.
3.
Heed all warnings.
4.
Follow all instructions.
5.
Only use replacement parts recommended
by Keiser Corporation.
6.
Replace defective components immediately
and/or keep the equipment out of use until
repaired.
7.
Routinely check and pay special attention to
components most susceptible to wear.
8.
Maximum weight of the rider shall not
exceed 300lbs (136kg).
9.
The cycle is NOT designed with a freewheel,
but a fixed gear system. When the flywheel is
in motion, the pedals will also be in motion.
10. Never remove your feet from the pedals while the
flywheel is in motion as serious user injury may occur.
11. Always secure the pedal clip strap by placing your foot
on the pedal and in the toe cage. Locate the strap and
pull up on it to tighten. It should be snug but not too
tight to cause discomfort.
12. The resistance shifter allows you to safely slow or stop
the motion of the flywheel. Move the resistance shifter
away from you to increase the gear and slow the motion
of the flywheel.
13. This cycle is intended for use in training areas of
organizations such as sport associations, educational
establishments, hotels, clubs and studios, where
access and control is specifically regulated by the
owner (person who has the legal responsibility).
14. Keep children and pets clear from the unit at all times,
especially while in use.
15. The cycle should be positioned on a stable, level,
horizontal surface.
16. There should be a clearance of no less than 24-inches
(0.6 m) of free area on all sides of the cycle. When
cycles are positioned adjacent to each other the free
area may be shared.
17. Movements such as pedaling at high speeds or
pedaling while standing are considered advanced
techniques, and should only be performed when the
rider has reached an advanced level.
18. Ensure that all adjustment handles that could interfere
with the user’s movement are not left projecting as to
come in contact with the rider during operation.
19. Before dismounting, push the resistance lever to the
most forward position to bring both the flywheel and
pedals to a complete stop.
WARNING: This symbol appearing throughout this manual means PAY ATTENTION! BE ALERT! When
you see this warning symbol, your safety is involved. It is being used to call attention to POTENTIAL
hazards that could result in personal injury or loss of life.
IMPORTANT SAFETY INSTRUCTIONS
24-inche
s (0.60 m)
24-inche
s (0.60 m)
24-inche
s (0.60 m)
