ATTACHING THE COMPUTER
Step 1:
Remove the Computer from its packaging on the Top Frame, be careful not to damage the
Computer or it’s wiring. With the #2 Phillips screwdriver remove the Computer Mounting Screw from
the Handlebar Tube (located at the top of the Top Frame). Set this screw aside for later use.
Step 2:
Coil the Computer Cable into the Computer Mount Cavity (Fig. 8). Slide the Computer up into
the two tabs (Fig. 9). Insert and secure the screw removed in Step 1 using the #2 Phillips screwdriver.
Step 3:
Follow this step to check your Shifter and Computer Cable Connections. Begin with the Shifter
Lever in the down position. While holding the free end of both Pedal Mounts, rotate the Cranks one
full turn or until the Computer turns on. The display will show “ODO” for 10 seconds, then cycle the
Shifter forward and backward from “GEAR 1” through “GEAR 24” (Fig. 10, next page). If gears are
displayed with no problems, the Computer is working properly. If Gears are not found check the Shifter
and Computer Cable Connections.
Step 4:
Obtain the ratchet with 13mm socket, eight Hex Head Cap Screws (D2) and eight Small
Washers (C4). Secure the Top Frame to the Main Frame (Fig. 11, next page). Torque the screws to 23 Nm (17
ft-lbs), then insert the Rubber Caps (D1) into the holes of the Main Frame (Fig. 12, next page).
6
7
8
9
Summary of Contents for m5
Page 1: ...USER MANUAL...
