Page 8
DOC0935 (26 July 2022 12:02)
www.keit.co.uk
Back to Table of Contents
sufficiently protected from loading and twisting. The cable should ideally be routed above
ground to avoid accidental damage.
NOTE
Ensure the mains and data communication cable connectors
are dry prior to mating.
NOTE
Keep the dust caps fitted on connectors when not in use.
Never leave an exposed connector.
The communications flying leads provided with ASM0627-10-Z-Cx-Ex-Gx-D3x are Cat7
terminated in female RJ45 connectors. Either socket can be used to form a connection for
DCS or access a network. For DCS guidance refer to the Modbus TCP commissioning guide
(DOC0817) or OPC-UA commissioning guide (DOC0828); for copies contact
support@keit.co.uk.
To connect, line up the latching surfaces and push together. This forms an IP67 rated
connection. Standard RJ45 connectors can simply be plugged in but an IP rating cannot be
guaranteed.
Figure 4: CNLinko LP16 RJ45 Plug
Figure 5: CNLinko LP16 RJ45 socket
2.3.1. Connecting to the internal controller
To set up the IRmadillo in preparation for install, remote access is needed. This is performed
via Remote Desktop Connection from a local-access computer. A connection summary for
Remote Desktop connection is available below. For a detailed access guide contact
support@keit.co.uk.
The IRmadillo must be connected to the local-access computer either
a) via a common network; or
b) via a direct Ethernet-to-Ethernet connection
In the case of a), the network may need to be configured to allow Remote Desktop access
between the local-access computer and the IRmadillo controller.
This section assumes that your local-access computer is running Microsoft Windows.
However, we understand that Remote Desktop may be configured to work with a local-access
computer running Linux, Mac OS or other non-Windows operating systems.
