Q
u
N
exus
e
diTOr
37
Q
u
N
exus
2.0
4.10.1 p
iTCh
s
CaliNG
Use this dropdown to set the Pitch Scaling scheme for CV Out 1� You can set this to 1 Volt per Octave, 1�2
Volts per Octave, or Hertz per Volt (an older scaling scheme)�
4.10.2 G
aTe
l
eGaTO
aNd
s T
riG
These two checkboxes change the behavior of the Gate output signals� Checking the Gate Legato box will
keep the gate open as long as any key is held, allowing you to change pitches without retriggering the gate
off/on� Checking the Gate S Trig box will invert the gate so that gate on is 0V and gate off is 5V�
4.10.3 Cv OuTpuT
The CV Output table lets you route keyboard and MIDI signals to the Gate and CV outputs�
Input Source - selects which source(s) are routed to the output� This could be one or all of the keyboard/
sequencer tracks, USB MIDI Port 3, the MIDI expander port, clock, or a combination of many of these sources�
Channel - If the input source has a MIDI channel assignment (i�e� if it’s a sequencer track, or channel data
from USB MIDI Port 3) it must match this value�
MIDI Type - Choose the type of message to route from the Input Source to the Gate or CV output� Note: “Tilt
CV” will accept tilt data from a given keyboard/sequencer track, while “Pressure CV” will accept pressure from
a keyboard/sequencer track, and/or Channel Pressure (aftertouch) data from USB or Expander MIDI�
Gain/Offset/Curve/Min/Max - These mathematical modifiers are identical to the ones described in section
4�8�3, and are applied to the Input Source data before it is routed to the Gate or CV Outs�
4.10.4 Cv i
NpuT
The CV Input table lets you translate CV voltages to MIDI messages�
Channel - the MIDI channel to assign to the MIDI messages
CC # - the MIDI control change (CC) to assign to the MIDI messages
Gain/Offset/Curve/Min/Max - These mathematical modifiers are identical to the ones described in section
4�8�3, and are applied to the voltage data before it is routed to the MIDI Device Out
MIDI Device Out - here you can select if the CV input MIDI messages are routed to USB3, the MIDI Expander
port, or both�
4.10.5 Cv T
riMs
The CV Trims window is accessible from the Hardware Menu� More information in Section 4�7�3�4 CV Trims
Summary of Contents for QuNexus RED
