P
Parts list
Path isolation resistance
Performance verification
Contact potential tests
Environmental conditions
Path resistance tests
Recommended equipment
Principles of operation
Block diagram
Relay control
Switching circuits
R
Recommended verification equipment
Repacking for shipment
Replaceable Parts
S
Scanner card detection
Scanner option bus query
SCPI scanner commands
Signal limitations
Relay input signal limitations
Special handling of static-sensitive
devices
Specifications
Summary of SCPI scanner commands
T
Current measurements
Resistor testing
2-wire resistance tests
4-wire resistance tests
Typical connecting schemes
Current measurements
Board soldering and cleaning
precautions
Current connections
Current shunt locations
Recommended current shunt
values
Voltage connections
Typical connections for 2-wire resistance
scanning
Typical connections for 4-wire resistance
scanning
U
Unpacking and inspection
Handling precautions
Inspection for damage
Instruction manual
V
Voltage attenuation by path isolation
resistance
Summary of Contents for 2000-SCAN-20
