Section 3: Operation
Model 2000-SCAN Scanner Card User's Manual
3-14
2000-SCAN-900-01 Rev. A / April 2018
Current measurements
The 2000-SCAN is not intended for direct current measurements, but by installing a shunt resistor,
you can measure and calculate current. There are no dedicated channels or channel routing to
measure current on the scanner card. Shunt resistors can be installed for channels 1 and 6 to allow
for indirect current measurements. The following figure shows the typical configuration for current
measurement. Refer to
Current shunt locations
(on page 3-15) for information on shunt resistors.
Figure 21: Connections for current measurements
Figure 22: Connections for current measurements equivalent circuit