Model 2461 Interactive SourceMeter® Instrument Reference Manual
Section 6: SCPI command reference
2461-901-01 A/November 2015
6-137
Example
:STAT:QUES:COND?
Reads the Questionable Condition Register.
Also see
(on page C-7)
(on page C-16)
:STATus:QUEStionable:ENABle
This command sets or reads the contents of the questionable event enable register of the status model.
Type
Affected by
Where saved
Default value
Command and query
STATus:PRESet
Not applicable
0
Usage
:STATus:QUEStionable:ENABle <n>
:STATus:QUEStionable:ENABle?
<n>
The value of the register (0 to 65535)
Details
This command sets or reads the contents of the Enable register of the Questionable Event Register.
When one of these bits is set, when the corresponding bit in the Questionable Event Register or
Questionable Condition Register is set, the MSB and QSM bits in the Status Byte Register are set.
For detail on interpreting the value of a register, see
(on page C-16).
Example
:STAT:QUES:ENAB 8
:STAT:QUES:ENAB?
Enable bit 4, Limit 3 Fail, when the limit
test 3 failure value is exceeded. Check to
see that the value was set.
Also see
None
