Section 8: TSP command reference
Model 2461 Interactive SourceMeter® Instrument Reference Manual
8-92
2461-901-01 A/November 2015
opc()
This function sets the operation complete (OPC) bit after all pending commands, including overlapped commands,
have been executed.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
No
Usage
opc()
Details
This function causes the operation complete bit in the Status Event Status Register to be set when all
previously started local overlapped commands are complete.
Note that each node independently sets its operation complete bits in its own status model. Any
nodes that are not actively performing overlapped commands set their bits immediately. All remaining
nodes set their own bits as they complete their own overlapped commands.
Example
opc()
waitcomplete()
print("1")
Output:
1
Also see
(on page C-1)
(on page 8-340)
print()
This function generates a response message.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
No
Usage
print(
value1
)
print(
value1, value2
)
print(
value1, ..., valueN
)
value1
The first argument to output
value2
The second argument to output
valueN
The last argument to output
...
One or more values separated with commas
