Model 2461 Interactive SourceMeter® Instrument Reference Manual
Section 8: TSP command reference
2461-901-01 A/November 2015
8-211
Details
When the sweep is started, the instrument sources a specific voltage or current value to the device
under test (DUT). A measurement is made for each point of the sweep.
When the sweep command is sent, it clears any existing trigger models, creates a source
configuration list, and populates the trigger model. To run the sweep, initiate the trigger model.
The sweep continues until the source outputs the specified stop level. At this level, the instrument
performs another measurement and then stops the sweep.
When you specify a delay, a delay block is added to the sweep trigger model. This delay is added to
any source delay you may have set. For example, if you set 10 ms for the source delay and 25 ms for
the sweep delay, the actual delay is 35 ms.
The range type specifies the source range that is used for the sweep. You can select the following
options:
•
Auto: The instrument automatically goes to the most sensitive source range for each source level
in the sweep.
•
Best fixed: The instrument selects a single fixed source range that accommodates all the source
levels in the sweep. This avoids overshoots during sweeps.
•
Fixed: The source remains on the range that is set when the sweep is started. If a sweep point
that exceeds the capability of the source range, the source outputs the maximum level for that
range.
Example
reset()
smu.source.func = smu.FUNC_DC_VOLTAGE
smu.source.range = 20
smu.source.sweeplinear("VoltLinSweep", 0, 10, 20, 1e-
3, 1, smu.RANGE_FIXED)
smu.measure.func = smu.FUNC_DC_CURRENT
smu.measure.range = 100e-6
trigger.model.initiate()
Reset the instrument to its defaults.
Set the source function to voltage.
Set the source range to 20 V.
Set up a linear sweep that sweeps
from 0 to 10 V in 20 steps with a
source delay of 1 ms, a sweep
count of 1, and a fixed source
range. Name the configuration list
that is created for this sweep
VoltLinSweep
.
Set the measure function to
current.
Set the current range to 100
µ
A.
Start the sweep.
Also see
(on page 3-53)
(on page 8-259)
