Section 8: TSP command reference
Model 2461 Interactive SourceMeter® Instrument Reference Manual
8-232
2461-901-01 A/November 2015
Example 3
status.request_enable = 0
Clear the register.
Also see
(on page C-1)
(on page C-16)
status.standard.enable
This attribute reads or sets the bits in the Status Enable register of the Standard Event Register.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
status.preset()
Not applicable
0
Usage
standardRegister
= status.standard.enable
status.standard.enable =
standardRegister
standardRegister
The value of the Status Enable register of the Standard Event Register (0 to 255)
Details
When a bit in the Status Enable register is set on and the corresponding bit in the Standard Event
Status register is set on, the ESB bit of the Status Byte Register is set to on.
To set a bit on, send the constant or value of the bit as the
standardRegister
parameter.
You can set the bit as a constant or a numeric value, as shown in the table below. To set more than
one bit of the register, you can send multiple constants with + between them. You can also set
standardRegister
to the sum of their decimal weights. For example, to set bits B0 and B2, set
standardRegister
to 5 (which is the sum of 1 + 4). You can also send:
status.standard.enable = status.standard.OPC + status.standard.QYE
When zero (0) is returned, no bits are set. You can also send 0 to clear all bits.
The instrument returns a decimal value that corresponds to the binary-weighted sum of all bits set in
the register.
Bit
Decimal
value
Constant
When set, indicates the following has occurred:
0
1
status.standard.OPC
All pending selected instrument operations are
complete and the instrument is ready to accept new
commands. The bit is set in response to an
(on page B-6) command or TSP
(on page 8-
92) function.
1
2
Not used
Not used.
2
4
status.standard.QYE
Attempt to read data from an empty Output Queue.
3
8
Not used
Not used.
4
16
Not used
Not used.
5
32
Not used
Not used.
6
64
Not used
Not used.
7
128
status.standard.PON
The instrument has been turned off and turned back
on since the last time this register was read.
