The bottom half of the touchscreen display contains multiple
screens that you can swipe to access additional information
and settings:
• SOURCE swipe screen: Displays the source
settings. When the output is on, this displays either
the programmed source value or the actual source,
depending on the setting of source readback. On the
source swipe screen, you can set the source range,
source value, and source limit.
• SETTINGS swipe screen: Allows you to turn features on
and off, such as the measurement filter, math functions,
relative offset, and NPLCs.
• GRAPH swipe screen: Shows a graph of the readings in
the presently selected buffer. Touch the graph icon on the
right side of the graph swipe header to open a full-screen
graph view.
• STATISTICS swipe screen: Contains statistics based on
the readings in the active buffer.
• USER swipe screen: If set up (remote commands only),
displays information that you can define through a remote
interface.
An example of the SETTINGS swipe screen is shown below.
In the SETTINGS swipe screen shown here, the Auto Zero
feature is turned on. The other settings are turned off.
Connect
