2600AS-901-01 Rev. B / September 2008
Return to
3-21
Series 2600A System SourceMeter® Instruments Reference Manual
Section 3: Basic Operation
Recalling a saved setup
Setups can be recalled from internal nonvolatile memory or a USB flash drive at any time. To recall
a saved setup:
1.
Press the
MENU
key to access the main menu.
2.
Select
SETUP
, then press
ENTER
.
3.
Select the
RECALL
menu item, then press
ENTER
.
4.
Choose one of the following:
•
INTERNAL
•
USB1
5.
(
INTERNAL
only) Do one of the following:
•
Select the user number (1 through 5), then press
ENTER
•
Select
FACTORY
to restore factory defaults, then press
ENTER
.
6.
(
USB1
only) Select the appropriate file and then push
ENTER
.
To select power-on setup
1.
Press the
MENU
key to access the main menu.
2.
Select
SETUP
, and then press
ENTER
.
3.
Select
POWERON
, and then press
ENTER
.
4.
Do one of the following:
•
Choose
FACTORY
to load the original defaults
•
Select
USER NUMBER
(1 through 5) to load a user preference.
5.
Press
ENTER
.
6.
Press
EXIT
to return to the main menu.
Saving user setups from a command interface
Saving and recalling user setups
The
setup.save
and
setup.recall
functions are used to save and recall user setups:
Restoring the factory default setups
The reset functions return the Series 2600A to the original factory defaults:
setup.save(n)
setup.recall(n)
Where:
n
=
1, 2, 3, 4
or
5
-- Save present setup to nonvolatile memory.
-- Recall saved user setup from nonvolatile memory.
reset()
or
*rst
-- Restore all factory defaults.
smua.reset()
-- Restore Channel A defaults.
smub.reset()
-- Restore 2602A/2612A/2636A Channel B defaults.
setup.recall(0)
-- Restore all factory defaults.
