Section 2: General operation
Model 2657A High Power System SourceMeter® Instrument Reference Manual
2-14
2657A-901-01 Rev. B/December 2012
Press the
EXIT
key to return to a previous menu.
The following table contains descriptions of the configuration menus, as well as cross-references to
related information. To select a menu, press the
CONFIG
key and then the front-panel key associated
with the menu (see the description column in the following table).
To access, press the
CONFIG
key and then:
Options
For more information, see:
SRC
V-source sense, low range,
protection; sink; I-source low
range
MEAS
V-sense and measure low
range; I-measure low range;
and auto-zero
LIMIT
V-source and I-source
compliance limits
SPEED
Measurement speed (NPLC)
(on page 2-78)
REL
Set relative values
FILTER
OUTPUT ON/OFF
Set off-state, off-function
(on page 2-66)
TRIG
Set trigger in, count, interval,
and delay
STORE
Set buffer mode, count, and
destination
(on page 3-6)
Setting values
Setting a value
You can adjust a value using either the
Navigation wheel method
or
Numeric entry method
(using
the keypad).
Navigation wheel method:
1. Use
the
CURSOR
arrow keys (or turn the navigation wheel
) to move the cursor to the digit
that needs to be changed.
2. Press the navigation wheel
or the
ENTER
key to enter edit mode. The EDIT indicator is
illuminated.
3. Rotate the navigation wheel
to set the appropriate value.
4. Press
the
ENTER
key to select the value or press the
EXIT (LOCAL)
key to cancel the change.
5. To return to the main menu, press the
EXIT (LOCAL)
key.
Numeric entry method:
The numeric entry method may only be used if the numeric keypad is enabled.
Quick Tip
NOTE
Summary of Contents for 2657A
Page 3: ......
