Series 3700 System Switch/Multimeter Reference Manual
Section 9
:
Instrument Control Library (ICL)
Document Number: 3700S-901-01 Rev. A / August 2007
9-213
tsplink.trigger[N].mode
Attribute
The trigger operation/detection mode.
Usage
To read trigger operation/detection mode:
mode = tsplink.trigger[N].mode
To write trigger operation/detection mode:
tsplink.trigger[N].mode = mode
N
: (In) The trigger line (1
–3).
mode
: (In/Out) Trigger mode.
Remarks
This attribute controls the mode in which the trigger event detector as well as the
output trigger generator will operate on the given trigger line. mode can be one of the
following values:
tsplink.TRIG_FALLING
Detect falling edge triggers as input. Assert a TTL-low pulse for output.
tsplink.TRIG_EITHER
Detect rising or falling edge triggers as input. Assert a TTL-low pulse for output.
tsplink.TRIG_SYNCHRONOUSA
Detect falling edge triggers as input and automatically latch and drive them low when
detected. Release a latched line for output.
tsplink.TRIG_SYNCHRONOUSM
Detect rising edge triggers as input. Assert a TTL-low pulse for output.
Also see
tsplink.trigger[N].assert
(on page 9-212)
tsplink.trigger[N].clear
(on page 9-212)
tsplink.trigger[N].overrun
(on page 9-213)
tsplink.trigger[N].release
(on page 9-214)
tsplink.trigger[N].triggersource
(see "tsplink.trigger[N].triggerstimulus" on page 9-214)
tsplink.trigger[N].wait
(on page 9-214)
tsplink.trigger[N].overrun
Attribute
Event detector overrun status.
Usage
overrun = tsplink.trigger[N].overrun
overrun
: (Out) Trigger overrun state.
N
: (In) The trigger line (1
–3).
