Series 3700 Cable & Connector Instructions
Model 3792-KIT104-R
The Model 3792-KIT104-R kit is a 104-pin solder-cup connector kit terminated with a male D-sub connector.
Figure 13: 104-pin male D-sub connector kit assembled
WARNING
Make sure the instrument that you are installing is in a powered-down state
with all cables unplugged. Failure to install an instrument in a discharged
state may cause personal injury or death from electrical shock. Do not
exceed the maximum specifications of the switching module.
To prevent electrical shock, observe the following safety precautions:
•
Both ends of the cable must be connected before applying any power
to the system.
•
Remove all power in the system before connecting the cable to a
switching module or external circuitry.
•
Both D-sub connector shells of this cable must be connected to a
safety earth ground. A shock hazard exists when voltage levels greater
than 30V RMS, 42.4V peak, or 60V DC are present.
Maximum signal level
The Model 3792-KIT104-R connector kit is rated for 300V RMS.
Maximum current rating
The Model 3792-KIT104-R connector kit maximum current is 5.0A.
Pin number identification
Pin number identification for the Model 3792-KIT104-R D-sub connector is shown Figure 14 below:
Figure 14: Model 3792-KIT104-R kit pin number identification
Male D-sub connector:
1
64
85
22
43
21
84
104
42
63
Contacts
The contact is 22 AWG maximum, and an insertion tool (not included) is required (part number 3791-CIT).
PA-949 Rev. D / May 2011
13
