In this section:
General operation .................................................................... 3-1
General operation
This section provides information needed to use the 3762 10-channel 2 Form A High-Voltage Card
with the Model 3706A system switch mainframe. Once the card is installed in the mainframe, refer to
the
Series 3700A System Switch/Multimeter Reference Manual
for complete operating instructions.
Safety hazards
To prevent electrical shock that could cause injury or death, never make or break
connections while the equipment is powered on. User supplied lethal voltages may be
present on the PC board or the connections. Turn off the equipment from the front panel,
disconnect the main power cord, and discharge stored energy in external circuitry before
making or breaking cable connections. Putting the mainframe equipment into an output-off
state does not guarantee that the outputs are powered off if a hardware or software fault
occurs. Precautions must be taken to prevent a shock hazard by surrounding the test
device and any unprotected leads (wiring) with double insulation for 1000 volts, Category I.
Section 3
General operation
