Section 13: LPT library function reference
Model 4200A-SCS Parameter Analyzer Reference Manual
13-212
4200A-901-01 Rev. C / February 2017
Code
Status or error titles
-514
IFC abort.
-515
GPIB timed out.
-516
Invalid function number.
-517
TCT timeout.
-518
No listeners on bus.
-519
Driver problem.
-520
Bad slot number.
-521
No listen address.
-522
No talk address.
-523
IBUP Software configuration error.
-524
No utility function.
-550
EEPROM checksum error in %s: %s.
-551
EEPROM read error in %s: %s.
-552
EEPROM write error in %s: %s.
-553
%s returned unexpected error code %d.
-601
System software internal error; contact the factory.
-602
Module load error: %s.
-603
Module format error: %s.
-604
Module not found: %s.
-610
Could not start %s.
-611
Network error.
-612
Protocol error.
-620
Driver load error. Could not load %s.
-621
Driver configuration function not found. Driver is %s.
-640
%s serial number %s failed diagnostic test %d.
-641
%s serial number %s failed diagnostic test %d with a fatal fault.
-650
Request to open unknown channel type %08x.
-660
Invalid group ID %d.
-661
Invalid test ID %d.
-662
Ill-formed list.
-663
Executor is busy.
-664
Invalid unit ID %d.
-701
Error configuring serial port %s.
-702
Error opening serial port %s.
-703
Call kspcfg before using kspsnd or ksprcv.
-704
Error reading serial port.
-705
Timeout reading serial port.
-706
Terminator not received before read buffer filled.
-707
Error closing serial port %s.
-801
Exception code %d reported from VPU in slot %d, channel %d.
-802
VPU in slot %d has reached thermal limit.
-803
Start and stop values for defined segmented arb violate minimum slew rate.
-804
Function not valid in the present pulse mode.
-805
Too many points specified in array.
-806
Not enough points specified in array.