Appendix G: Using a Cascade Microtech PA200 Prober
Model 4200A-SCS Parameter Analyzer Reference Manual
G-2
4200A-901-01 Rev. C / February 2017
Product Name:
PBRS232 Interface for ProberBench NT
Product Version:
3.00
Copyright:
©
Karl Suss 1998 - All Rights Reserved
Kernel:
3.000000 ProberBench Kernel Version 3.10 12-7-98
Control Box:
2.400000 ProberBench Control Box 2.4
Product Name:
Navigator for ProberBench NT
Product Version:
3.1 (Feb 12, 1999)
Copyright:
©
Karl Suss 1998 - All Rights Reserved
Kernel:
3.000000 ProberBench Kernel Version 3.10 12-7-98
Control Box:
2.400000 ProberBench Control Box 2.4
Product Name:
TableView for ProberBench NT
Product Version:
3.1 (Feb 12, 1999)
Copyright:
©
Karl Suss 1998 - All Rights Reserved
Kernel:
3.000000 ProberBench Kernel Version 3.10 12-7-98
Control Box:
2.400000 ProberBench Control Box 2.4
Product Name:
Remote Communicator for ProberBench NT
Product Version:
3.00
Copyright:
©
Karl Suss 1998 - All Rights Reserved
Kernel:
3.000000 ProberBench Kernel Version 3.10 12-7-98
Control Box:
2.400000 ProberBench Control Box 2.4
Probe station configuration
Make sure that you are familiar with the Cascade MicroTech
®
PA200 Prober and its supporting
documentation before you attempt setup, configuration, or operation.
To set up and configure the PA200 prober for use with the 4200A-SCS, you will:
•
(on page G-6)
•
(on page G-10)
•
Create a site definition and define a probe list
(on page G-13)
•
Load, align, and contact the wafer
(on page G-14)
Set up communications
You need to set communications between the 4200A-SCS and the prober.
To make the connections:
1. Connect the ProberBench NT computer’s COM2 port to the 4200A-SCS COM1 port using a DB9
female to DB9 female cable (shielded null modem cable). See the following figure.
