Appendix K: Using a Signatone CM500 Prober
Model 4200A-SCS Parameter Analyzer Reference Manual
K-18
4200A-901-01 Rev. C / February 2017
Probesubsites Clarius project example
The following procedure configures a Clarius project to execute testing and automatic wafer stepping
to all programmed subsites.
Use the 4200A-SCS to do this example. Use Clarius to open and run the
probesubsites
project
using the new configuration file, which will allow you to execute the project for this prober.
This project uses a Series 700 Switching System and the
connect
actions to change the instruments
connected to each pin without changing the physical configuration.
From Clarius:
1.
Choose
Select
.
2.
Select the
Projects
library.
3.
Create the
probesubsites
project.
4.
Select
Configure
.
5.
In the project tree, select the
prober-init
action.
6.
Set the
mode
to
6
.
Figure 826: Set prober-init mode parameters
7.
Set the
subprobtype
. If the CM500 prober is not at its first site, set the
subprobtype
to
1
;
otherwise, set it to
0
.
8.
In the project tree, select
probesubsites_1
.
9.
Select
Run
to execute the project.
