Model 4200A-SCS Parameter Analyzer Reference Manual
Section 6: Clarius
4200A-901-01 Rev. C / February 2017
6-167
Figure 329: Device Pin / Switch Connections settings example
Parameter Properties/Degradation Targets
Tests:
The tests in the subsite that have output values assigned.
Output Values:
The name of the output value.
%:
The percent of change between the post-stress output value reading compared to its pre-stress
output value reading. The % Change is calculated and listed in the subsite Analyze sheet. The
percent of change for post-stressed output values is calculated as follows:
% Change = ABS[(Post-Stress Reading
−
Pre-Stress Reading) / Pre-Stress Reading x 100]
Abs:
The value of the absolute change of the post-stress output value reading compared to its pre-
stress output value reading. Abs is calculated and listed in the subsite Analyze sheet as Abs Change.
The absolute change for post-stressed output values is calculated as follows:
Abs Change = ABS[Post-Stress Reading
−
Pre-Stress Reading]
Degradation Targets:
An output value is assigned as a target in percentages or an absolute value
and is evaluated for degradation. When all targets for a device are reached, that device is no longer
tested. Subsequent cycles bypass the device tests that reached all its targets. Refer to
(on page 6-168) for more information.
