Model 4200A-SCS Pulse Card (PGU and PMU) User's Manual
Section 8: Testing flash memory
4200A-PMU-900-01 Rev. A December 2020
8-15
Use KPulse to create and export Segment Arb waveforms
This example demonstrates how to create a program and erase waveform using the KPulse flash
example file.
You will export the waveforms, which you can import into the Clarius Configure pane for the subsite
when Segment Stress/Measure Mode is selected.
Each segment pulse waveform must have the same total time. The minimum programmed time for
any segment is 20 ns (20E-9 s), but actual output waveform performance is determined by the
channel output capability.
To use KPulse to create and export Segment Arb waveforms:
1. If they are open, close Clarius and KCon.
2. Open
KPulse
.
3. Select
File > Load Setup
.
4. Select
Kpulse_Flash_Example_01.kps
.
5. Select
Open
.
6. Select
Edit Segarb
. This opens the edit dialog box for both channels. You can use copy and
paste to copy information between the channels.
7. Note that the trigger is set to
1
in the first and fifth segments. These are the first segments in the
program and erase pulses in a typical two pulse program/erase waveform. It is recommended
that you set trigger to
1
for the first segment of each pulse in a waveform.
8. For each unique waveform, export each to a file as described below.
To export a Segment Arb waveform file:
1. Select
Tools
.
2. Select
Export Segment Arb
to open the Segment Arb Export dialog box.
Figure 169: Segment Arb Export dialog box
3. Select the pulse card and channel for the waveform to be exported.
