Model 4200A-SCS Parameter Analyzer Reference Manual
Appendix H: Using a Micromanipulator 8860 Prober
4200A-901-01 Rev. C / February 2017
H-19
6. Click Set X, Y die size button in the Setup Options window. The Set X, Y Die size dialog box
opens.
7. Set X, Y Die size button.
8. If die size is known, enter it. If not known, calculate (see
(on page H-16)).
Set spline pattern (optional)
The order of selection of the die, the spline pattern (change using edit die program), and the
reference die location determine test order sequence.
To set spline pattern:
1. Click the
Edit Die Program Parameters
button on the Die Program Tools window of pcWfr. The
Edit Die Program Parameters dialog box opens.
Figure 711: Die Program Tools window
2. Click the
Spline Pattern
button on the Edit Die Program Parameters dialog box. The Spline
Pattern window will open.
Figure 712: Spline Pattern window