Section 6: Clarius
Model 4200A-SCS Parameter Analyzer Reference Manual
6-112
4200A-901-01 Rev. C / February 2017
Add a group
To add a group:
1. Click
Add
(near the lower left corner of the UTM UI Editor). A new tab for the group is added.
2. Complete the
Group Name
. The group name entered in this view appears exactly as entered.
Use standard characters a-z, A-Z, 0-9, and space.
3. Select the
Group Position
. This position is in relation to the UI image bitmap. Select a clock hour
from the Group Position list. The number of parameters in each group defines the final layout. For
example, if two groups next to each other have a lower number of parameters, the groups will
have more space between them. On the 4200A-SCS display, there is limited space at 12 o’clock
(above the image) and 6 o’clock (below the image).
4. Select the
Group Type
.
5. Select
Fixed Position
,
Collapsible
, and
Visible Frame
as needed.
6. Add and configure the parameters. Refer to
Edit the attributes for a test parameter
(on page 6-
115) for detail.
7. Click
OK
.
Figure 276: Example group view for pulse timing
