Model 4200A-SCS Parameter Analyzer Reference Manual
Section 6: Clarius
4200A-901-01 Rev. C / February 2017
6-153
Choose the stress mode
You can select one of these stress, measure, or cycle modes:
•
Stress/Measure Mode: Test-stress-test-stress cycles, such as hot carrier injection (HCI) or
negative bias temperature instability (NBTI) studies.
•
Segment Stress/Measure Mode: Stress/Measure mode for a segment. Segment Stress/measure
mode is similar to the Stress/Measure Mode, except device stressing is provided by pulse cards
using the Segment Arb
®
pulse mode. You can use SMUs to provide bias voltage and current limit
for the devices, but you cannot use them to measure stress.
•
Cycle Mode: Repeats cycles through the subsite tests without stressing the devices.
To choose the stress-cycle mode:
1. From the project tree, select the subsite.
2. Select
Configure
.
3. In the right pane, select
Stress Mode Setup
.
4. Select
Enable Stress/Measure/Cycles
.
5. Select the
Stress/Measure Mode
,
Segment Stress/Measure Mode
, or
Cycle Mode
.
Figure 313: Stress Mode Setup pane
