Model 4200A-SCS Parameter Analyzer Reference Manual
Section 6: Clarius
4200A-901-01 Rev. C / February 2017
6-175
Set the segment stress/measure mode Subsite Stress Properties
The following topics describe the options that are available when you are setting the properties for the
Segment Stress/Measure Mode.
The test sequence for the Segment Stress/Measure Mode is the same as the test sequence for the
basic
(on page 6-189).
Figure 335: Segment stress/measure properties
Import KPulse Segment Arb waveform files
If you exported a Segment Arb waveform file from KPulse, you can import it into the Segment
Stress/Measure Mode Properties pane.
Segment Arb waveform files have the extension
.ksf
and are normally stored at the following
location:
C:\s4200\kiuser\KPulse\SarbFiles
To import a Segment Arb waveform file:
1. In the Stress Properties pane, select
Segment Arb File
.
2. Select the file.
3. Select
Open
.
