Section 6: Clarius
Model 4200A-SCS Parameter Analyzer Reference Manual
6-304
4200A-901-01 Rev. C / February 2017
Graph defaults
The My Settings Graph Defaults option allows you to set the defaults that are used for the Analyze
graph when graphs are generated from a Run History:
•
Default Line Width:
Sets the line width that is used if a line is displayed.
•
Default Data Display:
Select
Points
to display each data point on the graph,
Lines
to display a
line connecting the points, or
Points and Lines
to display both.
•
Y1 Default Most Recent Data Color:
The color that is used for data graphed against the Y1
axis.
•
Y1 Default Older Data Color:
The color that was used for data graphed against the Y1 axis. To
have Clarius select the color automatically, select
Auto (cycle through colors)
.
•
Y2 Default Most Recent Data Color:
The color that is used for for data graphed against the Y2
axis.
•
Y2 Default Older Data Color:
The color that was used for data graphed against the Y2 axis. To
have Clarius select the color automatically, select
Auto (cycle through colors)
.
Custom GPIB Abort Options
These options allow you to set the operations that occur when a GPIB abort is sent.
You can select that a
*RST
and
DCL
occur when an abort occurs.
If you enable Custom String, you can send a a user-defined GPIB command string to the instrument.
While most instruments will respond to the
DCL
command, instruments that are not SCPI compliant
will not. Erratic operation may result. Refer to the instruction manual for the instrument to determine
its capabilities.
Instruments are added to this list when they are added to the system through KCon. Instruments
added as General Purpose Test Instruments are shown. Refer to
Use KCon to add equipment to the
(on page 7-7) for more information.
To add a custom string, select the box to the left of the Custom String box for the instrument.
Project tree display options
You can select whether or not Clarius displays the project tree if you need more workspace. To hide
the project tree, click
<
at the top of the tree. Redisplay the project tree by selecting
>
.
Messages display option
You can hide the Messages area at the bottom of the Clarius window. To hide Messages, select v. To
display the messages, select ^.
