3-16
DC Current Source Operation
Model 6220/6221 Reference Manual
Return to
(4).
Turn on the output
The
OUTPUT
key toggles the output state (on or off). When the output is
turned on, the OUTPUT indicator light turns on.
For
remote programming
, the command to control the output is
documented in
. The following example demonstrates proper
syntax.
Example
– Turns the output on:
The OUTPUT indicator will blink if the current source goes into compliance.
This indicates that the set current is not being delivered to the load. See
for details.
Remote programming – source output commands
lists the commands to configure and control the DC output. A
programming example to output DC current is also provided.
NOTE
In order to turn on the output, an interlock switch
must be connected to the INTERLOCK connector
on the rear panel of the Model 622x. Closing the in-
terlock switch will enable the OUTPUT allowing it
to be turned on. For details, see
.
OUTPut ON
‘ Turns output on.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
Summary of Contents for 6220
Page 16: ...Test Equipment Depot 800 517 8431 99 Washington Street Melrose MA 02176 TestEquipmentDepot com...
Page 24: ...Test Equipment Depot 800 517 8431 99 Washington Street Melrose MA 02176 TestEquipmentDepot com...
Page 453: ...Test Equipment Depot 800 517 8431 99 Washington Street Melrose MA 02176 TestEquipmentDepot com...
