Section 4: Maintenance
Model 9139B Probe Card Adapter Instructions
4-6
9139B-901-01 Rev. A / January 2019
12. Install a pogo pin in the socket.
13. Clean the flux from the solder connection (see
(on page 4-3) for more information).
14. Reinstall the probe card.
Replacing the vacuum connection
The vacuum connection of the probe card adapter can be replaced if damaged.
To replace the vacuum connection:
1. Remove the vacuum connection.
2. Make sure all old sealant is removed from the threaded holes on probe card adapter.
3. Lightly apply standard pipe sealant to the new vacuum connection.
4. Install the new vacuum connection (do not over-tighten).
