In this section:
Introduction .............................................................................. 4-1
Equipment required for this example ........................................ 4-1
Device connections .................................................................. 4-2
Basic front-panel measurements .............................................. 4-3
Introduction
This example application makes a 2-wire resistance measurement using the front panel of the
instrument.
Set the function before making other instrument settings. Many of the settings are related to a
specific measure function. The applications in this manual use the order of operations to produce the
best results.
Equipment required for this example
Equipment required to perform this test:
•
One DMM6500
•
Two insulated banana cables.
•
One resistor to test, the example uses a resistor with a 9.75 k
Ω
rating
Section 4
Making basic front-panel measurements
