Section 6: SCPI command reference
Model DMM7510 7½ Digit Graphical Sampling Multimeter Reference Manual
6-22
DMM7510-901-01 Rev. B / May 2015
Example
ACAL:SCH RUN, DAY1, 8
ACAL:SCH?
Sets auto calibration to run every day at 8 am
and query to verify the settings.
Output:
RUN;DAY1;8
Also see
(on page 6-20)
CALCulate subsystem
The commands in this subsystem configure and control the math and limit operations.
:CALCulate2:<function>:LIMit<Y>:AUDible
This command determines if the instrument beeper sounds when a limit test passes or fails, or disables the
beeper.
Type
Affected by
Where saved
Default value
Command and query
Recall settings
Instrument reset
Power cycle
Measure configuration list
Save settings
Measure configuration list
Continuity: PASS
Other functions: NONE
Usage
:CALCulate2:<function>:LIMit<Y>:AUDible <state>
:CALCulate2:<function>:LIMit<Y>:AUDible?
<function>
The function to which the setting applies; see
Functions
<Y>
Limit number:
1
or
2
<state>
When the beeper sounds:
•
Never:
NONE
•
On test failure:
FAIL
•
On test pass:
PASS
Functions
VOLTage[:DC]
RESistance
TEMPerature
VOLTage[:DC]:RATio
VOLTage:AC
FRESistance
CONTinuity
DIGitize:VOLTage
CURRent[:DC]
DIODe
FREQuency[:VOLTage]
DIGitize:CURRent
CURRent:AC
CAPacitance
PERiod[:VOLTage]
Details
The tone and length of beeper cannot be adjusted.
