Chapter 4
26
Wiring Methods
The KUSB-3116 module contains both BNC connectors and 37-pin,
D-sub connectors, as shown in
Figure 5: KUSB-3116 Module
You can wire signals to the KUSB-3116 module in one of the
following ways:
•
Analog input signals
– You can wire analog input signals in one
of the following ways:
−
Using the BNC connectors labelled AD Ch0 to AD Ch15.
−
Using the appropriate pins on the Analog Input connector.
Refer to Appendix A in the
KUSB-3116
User’s Manual
for
information about the required mating connectors.
AD Ch0
An
alog
Inp
u
t
AD Ch1
AD Ch2
AD Ch6
AD Ch3
AD Ch5
AD Ch7
Dig
ital I
/O
C\T
, D
A
C
, Clk, T
rig
AD Trig
DAC Ch2
DAC Ch3
DAC Trig
AD Ch9
AD Ch10 AD Ch11
AD Ch13 AD Ch14 AD Ch15
DAC Ch0
DAC Ch1
DAC Clock
AD Clock
AD Ch12
AD Ch8
AD Ch4
Summary of Contents for KUSB-3116
