Chapter 5
58
Performing a Single-Value Digital Output Operation
Note:
Although the KUSB-3116 module contains 16 digital output
lines, the Quick Data Acq
application allows you to perform a digital
output operation on the lower eight digital output lines (lines 0 to 7)
only.
To verify that the module can output a single digital output value,
perform the following steps:
1.
Connect a digital output to digital output line 0 on the
KUSB-3116 module. Refer to
for an example of how to
connect a digital output.
2.
Click the
Control
menu.
3.
Click
Digital Output
.
4.
Select the appropriate KUSB-3116 module from the
Board
list
box.
5.
Click the appropriate indicator lights to select the types of signals
to write from the digital output lines. If you select a light, the
module outputs a high-level signal; if you do not select a light,
the module outputs a low-level signal. You can also enter an
output value for the lower eight digital output lines (0 to FF) in
the
Hex
text box.
6.
Click
Send
.
The values of the lower eight digital output lines are output
appropriately.
Summary of Contents for KUSB-3116
