Chapter 5
60
Performing a Pulse Output Operation
To verify that the module can perform a pulse output operation,
perform the following steps:
1.
Connect a scope to counter/timer 0 on the KUSB-3116 module.
Refer to
for an example of how to connect a scope (a
pulse output) to counter/timer 0.
Note:
The Quick Data Acq application works only with
counter/timer 0.
2.
Click the
Control
menu.
3.
Click
Pulse Generator
.
4.
Select the appropriate KUSB-3116 module from the
Board
list
box.
5.
Select either
Continuous
to output a continuous pulse stream or
One Shot
to output one pulse.
6.
Select either
Low-to-high
to output a rising-edge pulse (the high
portion of the total pulse output period is the active portion of
the signal) or
High-to-low
to output a falling-edge pulse (the low
portion of the total pulse output period is the active portion of
the signal).
7.
Under
Pulse Width
, enter a percentage or use the slider to select
a percentage for the pulse width. The percentage determines the
duty cycle of the pulse.
8.
Click
Start
to generate the pulse(s).
The results are displayed both in text and graphical form.
9.
Click
Stop
to stop a continuous pulse output operation. One-shot
pulse output operations stop automatically.
Summary of Contents for KUSB-3116
