4
Wiring Signals
47
4
4
4
4
4
4
4
4
Connecting Signals for Period/Pulse Width
Measurement Operations
shows how to connect counter/timer signals to your own
screw terminal panel to perform a period/pulse width measurement
operation on counter/timer 0. You specify the active pulse (high or
low) in software. The pulse width is the percentage of the total pulse
period that is active. Refer to the
KUSB-3116
User’s Manual
for more
information about pulse periods and pulse widths.
Figure 22: Connecting Counter/Timer Signals to a Screw Terminal Panel for
a Period/Pulse Width Measurement Operation
8
Signal Source
Counter 0 Clock
Digital Ground
18
Screw Terminal Panel
Summary of Contents for KUSB-3116
