Verifying the Operation of a Module
55
5
5
5
5
5
5
5
5
5
7.
Select
Differential
.
8.
Click
Get
to acquire a single value from analog input channel 0.
The value is displayed on the screen in both text and graphical form.
Performing a Single-Value Analog Output
Operation
To verify that the module can output a single analog output value,
perform the following steps:
1.
Connect an oscilloscope or voltmeter to analog output channel 0
on the module. Refer to
for an example of how to connect
analog output signals.
2.
Click the
Control
menu.
3.
Click
Single Analog Output
.
4.
Select the appropriate KUSB-3116 module from the
Board
list
box.
5.
In the
Channel
list box, select analog output channel 0.
6.
In the
Range
list box, select the output range of DAC0. The
default is ±10 V.
7.
Enter an output value, or use the slider to select a value, to output
from DAC0.
8.
Click
Send
to output a single value from analog output
channel 0.
The value that is output is displayed both on the slider and in the text
box.
Summary of Contents for KUSB-3116
