Verifying the Operation of a Module
59
5
5
5
5
5
5
5
5
5
Performing a Frequency Measurement Operation
To verify that the module can perform a frequency measurement
operation, perform the following steps:
1.
Wire an external clock source to counter/timer 0 on the
KUSB-3116 module. Refer to
for an example of how to
connect an external clock.
Note:
The Quick Data Acq application works only with
counter/timer 0.
2.
Click the
Acquisition
menu.
3.
Click
Measure Frequency
.
4.
Select the appropriate KUSB-3116 module from the
Board
list
box.
5.
In the
Count Duration
text box, enter the number of seconds
during which events will be counted.
6.
Click
Start
to start the frequency measurement operation.
The operation automatically stops after the number of seconds you
specified has elapsed, and the frequency is displayed on the screen.
7.
Click
Stop
to stop the frequency measurement operation.
Summary of Contents for KUSB-3116
