3-10
Setup and Installation
To install the board, perform the following steps:
1. Turn power to the computer and all attached equipment OFF.
2. Remove the computer chassis cover.
3. Select an available slot appropriate to the length of the board.
4. Loosen and remove the screw at the top of the blank adapter plate,
and then slide the plate up and out to remove.
5. If you are installing your own cables or the optional
C-3200/C-32NN ribbon cables, decide how to run the cables. Note
that the strain relief on the C-3200/C-32NN 40-pin connector may
need to be removed for clearance or to allow the cable to run in the
correct direction. Decide on the folds and orientation of the cables
but do not install them yet.
6. Insert and secure the board connector in the selected slot.
7. Route your cables or the C-3200/C-32NN cables from the outside of
the chassis through the slot in the adapter plate and connect them to
the appropriate 40-pin header. Fold the ribbon cable so that it does
not interfere with other boards in the chassis.
8. Replace the computer chassis cover.
9. Plug in all cords and cables not already connected.
10. Continue with the next section, “Checking Your Installation.”
