S530 Parametric Test System Administrative Guide
Section 2: S530 site preparation and installation
S530-924-01 Rev. D / September 2017
2-13
Chuck cables for optional probe card adapter
A set of chuck cables is included with the optional PCA-9139A probe card adapter. Model numbers of
cables vary based on the prober you are using. For example, the Keithley Field Service Engineer
(FSE) will install the cables shown in the following table for Tel P8 probers.
Model
Quantity
Description
CA-63-12
2
12 ft three-lug triaxial cables
237-TRX-T
1
Three-slot male to dual three-lug female triaxial tee adapter
237-BNC-TRX
1
High-voltage two-slot BNC to three-lug female triaxial adapter
If a different cable termination scheme is required, a customer-supplied solution can be used.
Optional probe card adapter vacuum requirement
9139A-PCA probe card adapter requirement: A 50.80 cm (20 in.) Hg (which is the same as 40.73
PSI) vacuum supply, with a hose connection of 0.64 cm (1/4 in.) outside diameter and 0.32 cm (1/8
in.) inside diameter.
Keithley field service engineer installation tasks
The Keithley field service engineer (FSE) will perform the following tasks:
Attach the keyboard arm and monitor arm to the system.
Install the keyboard and the mouse on the keyboard arm, and the monitor on the monitor arm.
Install the cable support arm to the system.
Install the probe card assembly (PCA) (if ordered) on the back of the system cabinet, and the
60190-PCA (probe card assembly) to the correct prober plate (customer-supplied from the prober
company). The prober plate is attached to the prober.
Plug in the system to your power facilities (supplied by your facilities department at the final
location for the S530 system cabinet) and power up the entire cabinet.
Verify communications of all instruments and with the properly configured prober.
Perform diagnostics and system verification tests of the entire S530 system, to include the
60190-PCA (if ordered).
Record all the information on the System Installation Form (see below for example).
