Performance Veri
fi
cation
Table 27: Test equipment
Item
Minimum requirements
Example
1.
Connectors
Connectors for hook up wire assemblies and test
resistors, item numbers 5, 6, 9, 10, and 11.
(Qty. 6) #10 fork lugs similar to Tyco part number
52951
(Qty, 14) Stackable, gold plated, banana plugs/jacks
similar to Pomona model 4897-0. Used for lower
current connections, and connection to the load
resistors (items 10 and 11) used for noise testing.
(Qty. 4) Sheathed Banana Jacks similar to Pomona
model 4834 to put connectors on the Resistors
(item 9).
2.
AC power source
Variable AC output from 90 to 265 VAC with at least
750 VA capacity
Kikusui PCR2000M
3.
Electronic load
Variable DC Load capable of 6 ADC and 40 VDC
B&K Precision 8510
4.
DC voltmeter
Voltage measurement at 12 mV through 40 V to better
than 100 ppm accuracy with the ability to multiply the
result by a scalar.
Keithley 2000 DMM
5.
High current hook up wire
(High current connections are
indicated with bold lines in the
setup illustrations)
18 AWG (minimum) hookup wire assemblies.
To perform all tests, the following wire assemblies need
to be created:
#10 fork lug to #10 fork lug, Qty 2, (included in
Guildline 92301 if used)
Stackable Banana to #10 fork lug, Qty 2
Stackable Banana to Bare Wire Qty 2.
Wire lengths are not critical.
6.
Low current hook up wire
(Low current connections are
indicated with light lines in the
setup illustrations)
22 AWG (minimum) hookup wires
To perform all tests, the following wire assemblies need
to be created:
Banana plug to Banana plug, Qty 2
Bare Wire to stackable Banana, Qty 2
Bare Wire to Banana, Qty 2
Wire lengths are not critical.
7.
50 m
Ω
precision shunt resistor
0.050
Ω
±100 ppm at 25 W ±4 ppm/°C temperature
coef
fi
cient
Guildline 9230A-50
8.
Current sense resistor cabling
Kelvin 4 terminal measuring cables for shunt resistor to
voltmeter
Guildline 92301 cable set
24
Series 2200 Multichannel Programmable DC Power Supplies Technical Reference
