Getting Started
Function button descriptions (cont.)
Button
Description
Saves the present settings to a speci
fi
ed setup memory location (1 to 30). Select the memory location
with the multipurpose knob, the up or down arrow keys, or the numeric keypad. The power supply
saves the settings after you push
Enter
.
Recalls a saved setting from a speci
fi
ed setup memory location (1 to 30). Select the memory location
with the multipurpose knob, the up or down arrow keys, or the numeric keypad. The power supply
recalls the settings after you push
Enter
.
Used to access the settings menu. Navigate the settings menu with the up and down keys. Push
Enter
to select the displayed menu item.
Selects the channel to be adjusted. The cursor indicates the currently selected channel.
Turns on or off all enabled output channels. The regulation mode, constant voltage (CV) or constant
current (CC), is shown on the display when the output is turned on.
Backs out of the selected function. If the instrument's focus is in a menu, pushing
Esc
will back up
one menu level.
Menu descriptions
Primary
Menu
Secondary
Menu
Description
>Default Set
Returns the instrument to the factory default setup values. This does not change the
setup memory.
>Enable
Channels
Enables or disables one or more output channels.
>Max Volt
Set
Sets the maximum output voltage value to which you can set on a speci
fi
ed output
channel.
>Output
Timers
After you select “On”, you can set a time period after which a speci
fi
ed output channel
will turn off.
> Protection
Settings
>Key Lock
When activated, this feature locks the front-panel controls and prompts for a password
to enable settings changes. This feature does not lock the power switch or the output
on/off switch.
>Track
CH1/CH2
Maintains a constant ratio between Channel 1 and Channel 2. The ratio is the ratio
that is present when tracking is turned on.
> Combine
CH1+CH2
Series V1+V2:
By wiring Channel 1 and Channel 2 in series, you can output up to
60 V. When this setting is activated the meter will read the combined voltage across
Channel 1 and Channel 2.
Parallel I1+I2:
By wiring Channel 1 and Channel 2 in parallel, you can drive up to 3 A.
When this setting is activated the meter will read the combined current from Channel
1 and Channel 2.
6
Series 2200 Multi-Channel Programmable DC Power Supplies User Manual
Summary of Contents for Series 2200
Page 2: ......
Page 4: ......
Page 10: ...Preface iv Series 2200 Multi Channel Programmable DC Power Supplies User Manual...
Page 37: ......
