kelda 24016, Installation Manual And User'S Manual

Electrical Installation

This shower requires a 230-240 VAC, 47 ~ 63Hz single phase supply. A single 3 Amp switched fused spur should be used 

for each Panel. Up to 12 Kelda showers can run from a single 32A 30mA RCBO.

Before connecting to power supply, make sure that the mains terminal is able to sustain 240V and 3A. All electrical instal-

lation to be carried out by an approved electrician in accordance with Part “P” U.K. Building Regulations and to the latest 

IEEE standards, or the appropriate regulations in the country of installation.

~~

~~

~~

~~

~~

~~

~~

~~

32A 30mA RCBO

(Up to 12 Showers)

3A Switched Fused Spur

AC 100-240V to DC 24V 

Transformer 60W (Sup-

plied)

Kelda Control Hub

1. 

Thread the power supply cable through the 16mm cable 
gland in the bottom left of the Control Hub.

2. 

Connect the cable to the 24V power terminal shown.    
(Polarity of connections is not important)

3. 

Using a 3mm flat screwdriver, tighten the connections 
down and tighten gland nut onto cable

Main Distribution Board

230-240V AC

Electrical Connection

10