Warning!
Factory settings
Air Volume
Your Kelda panel shower will have a different fan speed setting depending on what shower head and water flow rate your
product has. This will be set at the factory.
The hub will automatically adjust fan speed to match minor changes in flow rate which may result from changes in
water pressure.
However the fan speed can be manually changed if for example the flow regulator is changed to a different value or for
other site specific reasons.
Changing the Fan Speed (6 settings)
1.
The panel fan settings are pre-set by the factory.
2.
To change the fan speed settings, press ‘FAN’ button once. (There are 6 speed settings: 1-6)
3.
To display current fan speed set, press and hold ‘FAN’ button for 2 seconds. The number of LED flashes corresponds
to the speed setting selected.
Speed up/down button
Hold for 2 seconds for
Current Set Speed Set-
ting in Flashes
Fan Mode
LPM
Dynamic
1
4-6
Dynamic
2
4-6
Dynamic
3
4-6
Static
4
4
Static
5
5
Static
6
6
1.
Factory setting is Fan Mode 3 for all TMV Variants
2.
Fan Modes 1 and 2 can be used to fine tune perfor-
mance if necessary
3.
If changed, the new Fan Mode remains as default,
even after the power has been cycled.
Dynamic = Flow Sensor Present (93007100, 93008100,
93009100, 93010100)
Static = Time Flow variants (Solenoid Operated)
(93011100, 93003100, 93004100)
Fan Mode Settings
11
