VIDEO 18X 25000lm CRI82 Operating Instructions
4
6. uSE In aIR
The video light can also be used outside water but at low power level only. If the light gets too hot,
the over temperature protection will be activated and the power will be reduced automatically to avoid
overheating.
7. hOw tO OPEn thE CaSIng
Remove excess water from the outside before opening. Point the light slightly upward while opening to
avoid water from entering the housing.
Friction of the O-ring seal (and therefore force needed to open the cap) increases over storage time.
After long and deep dives the friction might increase too. To avoid high friction, regularly grease the O-ring.
8. MaIntEnanCE
After each use rinse well with fresh water. Do not allow water to dry on glass to avoid water marks
especially when diving in high mineral content brackish water. Rinse the black magnetic switch ring by
rotating 3-5 times to dislodge salt or sand on inner portion.
Care should be taken to avoid scratching of the O-ring seals. Keep seals clean of sand, hair, cloth fibers
or similar materials at all times. O-rings of the battery screw cap should be regularly inspected and
cleaned. Occasionally apply small amounts of silicone grease for lubrication. If not treated, the O-ring
will fail to provide proper sealing causing the light to malfunction.
•
Do not use sharp tools to remove the O-ring.
•
Never use a battery which appears damaged.
•
In case of a damaged lamp, contact your nearest
KELDAN
®
dealer.
•
Do not remove front glass cover (high operating voltage).
•
O-rings need to be replaced by
KELDAN
®
or an authorized dealer every 5 years.
9. tRanSPORt
IMPORTANT: The total capacity of the battery pack exceeds
the maximum capacity for Li-Ion battery allowed on airplanes!
Therefore the battery need to be disassembled for safe transport
on airplanes. After disassembling you can carry safely three single
batterypacks, each one will be below the maximum capacity limit.
The three batteries of a battery tray should always kept together
as a set and should not be mixed with batteries from another
battery tray. This will ensure maximum lifetime of the batteries. If
batteries show degraded capacity and need to be replaced they
should be replaced all three together at once.
