23
EN
Operating instructions CellaTemp PK / PKF / PKL xx
5
Confirm parameter value
►
Press [Enter]
> The display indicates the
parameter� The new value has
been saved and will take effect�
Adjust additional parameters
►
Start again with step 2�
Exit operating parameters layer
►
Wait 30 seconds
or
► Press [▲] or [▼] to change to the paramter
End.
Then press [Enter] to
change to the functional menu
► In the functional menu press [▲] or [▼] to change to the parameter
End
,
then press [Enter]�
The instrument features a keylock� Activate/deactivate the keylock as
follows:
► Press key [▲▼] simultaneously and hold them down for 10 sec.
> The display shows Loc or uLoc for 1 second to signalize the change�
If you press both keys [▲▼] only briefly, you will exit the layer
(ESC function)�
If [C�Loc] is displayed when attempting to change a parameter value,
a change is made via a parameter setting software at the same time
(temporary locking)�
If [S�Loc] is displayed, the sensor is permanently locked via software� This
locking can only be removed with a parameter setting software�
13.2 Test function
The pyrometer features an integrated diagnostics function to check signal proces-
sing, the switching output and the analogue output� It can be activated either using
the control keys or by a static signal (10���34 V according to IEC 61131-2) on Pin
