Master Instruments available to suit High Pressure Pump P12
The following manometer types can be directly mounted onto the High Pressure
Pump P12 without adapters. For further information about these products please
refer to the specific datasheet.
General notes:
The P12 pump allows the easy generation of pressure up to 700 bar. The pres-
sure media is hydraulic oil (BP HLP 22). The oil chamber volume of 148 cm
3
will
pressurise large dead volumes. The pump has a fine pressure adjuster and release
valve allowing precise pressure settings, making it the ideal test equipment for mano-
meters, pressure transmitters etc.
Using the High Pressure Pump P12:
Connect the master instrument to connection (a). Tighten the instrument at the
hexagon, ensuring that the green Eolastic flat seal is flush mounted.
Connect test unit to connection (e) with the high pressure quick-fit connection
(supplied).
Ensure that the pressure release valve (c) is not completely closed.
Adjust the fine adjuster (b) to “mid-travel”.
Close the release valve (c) fully clockwise.
Operate lever arm (d) to generate pressure.
Adjust pressure to required value using the fine adjuster (b). Turn fine adjuster
clockwise to increase pressure and anti-clockwise to decrease pressure until the
desired pressure is reached (displayed on master instrument).
After measurements, open valve (c) slowly to release pressure.
Remove test instrument
Note:
Due to thermodynamical effects in the system, the pressure may fall slightly for a
short time immediately after pressure generation. Use fine adjuster to stabilise pressure.
August 06
WARNING: To avoid possible destruction of the master- and test instru-
ments, do not exceed the max. operating pressure specified for these
instruments!
LEO 1
Accuracy: 0,2%
Intelligent Manometer
Accuracy: 0,1%
LEO 2
Accuracy: 0,1%
ECO 1
Accuracy: 0,5%
www.keller-druck.com
KELLER AG für Druckmesstechnik • St. Gallerstrasse 119 • CH-8404 Winterthur • Tel. +41 (0)52 235 25 25 • Fax +41 (0)52 235 25 00
